Forum: Power Adders
04-09-2006, 02:18 PM
|
Replies: 9
Views: 811
Re: Where are you buying your Superchargers from?
I didn't do much shopping around. Bought mine from Superchargers4Less and had it on my doorstep in 10 bussiness days. Needless to say, I was very impressed. However, I had to shop around for a few...
|
Forum: Technical Q&A. HOW TO's, TSB's & Warranty Items
03-31-2006, 11:05 PM
|
Replies: 3
Views: 520
Re: is there a way
There is a VERY kind lady over on Mach1Mustang.org site that will run an Oasis for you, Do a search.
|
Forum: Technical Q&A. HOW TO's, TSB's & Warranty Items
03-31-2006, 11:00 PM
|
Replies: 45
Views: 2,448
Re: Ticking Noise :(
+1. The stock valve guides in our cars are JUNK. I had the tick, Dealer replaced drvrs side cyl head, Tick is back AGAIN.
I got a P1SC 8# kit sitting on the floor gathering dust because the tick...
|
Forum: Engine & Drivetrain (Including trans & rear axles)
03-31-2006, 10:35 PM
|
Replies: 9
Views: 730
Re: squealing noise
+1 for Bad cam chain tensioner, I had one go bad. Dealer replaced it, Problem solved.
|
Forum: Exhaust System
03-12-2006, 04:02 AM
|
Replies: 6
Views: 706
Re: Official Sound Clip Thread
I've tried nine ways to sunday to make a "Decent" sounding clip but can't seem to do it. Shame to cause I got the complete SLP system and I know that it'd help some people decide.
|
Forum: Engine & Drivetrain (Including trans & rear axles)
03-11-2006, 08:31 PM
|
Replies: 28
Views: 1,051
|
Forum: Power Adders
03-09-2006, 02:28 PM
|
Replies: 17
Views: 1,261
|
Forum: Engine & Drivetrain (Including trans & rear axles)
03-09-2006, 02:12 PM
|
Replies: 21
Views: 853
|
Forum: Engine & Drivetrain (Including trans & rear axles)
02-28-2006, 05:29 PM
|
Replies: 83
Views: 4,072
|
Forum: Engine & Drivetrain (Including trans & rear axles)
02-26-2006, 02:11 PM
|
Replies: 31
Views: 1,099
Re: Rods and Pistons question???
I'm was in the same boat as you for awhile. My P1-SC 8# kit is still sitting in the corner, Mostly due to winter, But I also debated upgrading the short block. I finally decided that I'm gonna throw...
|
Forum: General Registry Discussion
02-09-2006, 04:51 PM
|
Replies: 84
Views: 2,132
|
Forum: General Registry Discussion
02-09-2006, 04:40 PM
|
Replies: 84
Views: 2,132
|
Forum: General Registry Discussion
02-09-2006, 04:04 PM
|
Replies: 8
Views: 657
|
Forum: General Registry Discussion
02-09-2006, 03:52 PM
|
Replies: 84
Views: 2,132
|
Forum: General Registry Discussion
02-09-2006, 03:27 PM
|
Replies: 84
Views: 2,132
Re: Former SVT Leader's Son Let Go From Ford
I've had enough of people blaming unions for everything. GM for instance: You can bet that the CEO of GM didn't lift a pencil until he had a signed contract but the empolyees are fat lazy americans...
|
Forum: Power Adders
02-09-2006, 02:15 PM
|
Replies: 25
Views: 2,057
Re: Difference between P1SC and P1SC 2?
Corey & Bonestock,
I don't mean to add any confusion to this issue guys but, The reciept for my Procharger from Superchargers4Less says:
Line1 - 1FL212-SCI 03-04 Mach 1 Stage ll IC System
Line2...
|
Forum: Fluid Systems (coolant, oil, fuel)
02-08-2006, 01:05 PM
|
Replies: 65
Views: 2,364
Re: Cobra fuel tank and pumps questions.
Bonestock,
That's still a good price. I had heard that the prices went up a little. I paid $670.00 + $20.00 for shipping so apparently, They haven't gone up too much.
Curious, Was it Steve at...
|
Forum: Fluid Systems (coolant, oil, fuel)
02-07-2006, 05:35 PM
|
Replies: 65
Views: 2,364
Re: Cobra fuel tank and pumps questions.
I'm trying to remember exactly Joe, But I'm pretty sure that I adjusted the float "Down" When I installed the Cobra pumps & tank ~1/2". After about a half hour of measuring the stock vs new setups of...
|
Forum: Power Adders
02-06-2006, 09:05 PM
|
Replies: 28
Views: 1,688
Re: Blow through vs. Draw through
After alot of reading on the subject, I followed Corey's & SLDeros advice and bought the MAF.ia also. I was just curious about how to convert to a draw-through just in case I run into trouble.
...
|
Forum: Engine & Drivetrain (Including trans & rear axles)
02-06-2006, 08:57 PM
|
Replies: 15
Views: 681
Re: Another cracked tailshaft!!!
You should be able to grab second gear w/out breaking tailshafts. I'd check into the motor mount movement a little more. May help to point you in the right direction. $.02
|