|
||
|
|
||
|
|||||||
| Power Adders Superchargers, Turbos, Nitrous, etc... |
 |
|
|
Thread Tools | Display Modes |
01-18-2011, 10:13 PM
|
#1 | |
|
Torque-a-licious
 
Join Date: Jun 2007
Location: Foster City, CA
Posts: 1,516
|
What belt size? (2.76, 2lb lower, BF snub/idlers)
Hey guys... I have looked on BF's site, and my combo doesn't have a size listed, and I can't seem to make much sense of the chart on Metco's site... So. What size belt (round-about) should I be running with my setup?
I am currently running a Gates K080745 with a BF 2.76" upper, 4 piece BF idler set with snub idler, and a 2lb Metco lower will be going on next. Any insight into what I need to run would be much appreciated. I looked under the hood today and the tensioner is a bit off of the center mark, to the right, towards the raised side. I'm not sure if I should check that when the car is running or not. It has sat since last night when I checked it today. Thank you for the help.
__________________
Cobra motor in. 422/453tq With 2lb lower and re-tune: 492/502tq Quote:
|
|
|
|
|
01-19-2011, 10:05 AM
|
#2 |
|
Mach1 member
 
Join Date: Aug 2003
Location: East Haven, CT
Posts: 3,349
|
Re: What belt size? (2.76, 2lb lower, BF snub/idlers)
__________________
2011 Mustang GT Grabber Blue Automatic 2003 Mach 1 Whipple 2.3 718 rwhp 735 rwtq @25 psi SOLD |
|
|
|
|
01-19-2011, 12:09 PM
|
#3 | |
|
Torque-a-licious
Join Date: Jun 2007
Location: Foster City, CA
Posts: 1,516
|
Re: What belt size? (2.76, 2lb lower, BF snub/idlers)
Thank you, I never thought of Cobra Bob. Someone gave me the link the other night to there with the recommended size.
__________________
Cobra motor in. 422/453tq With 2lb lower and re-tune: 492/502tq Quote:
|
|
|
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
<
Linear Mode
