Eaton swap dyno 445 hp and 380 tq

[Derek]

Great numbers however it took some effort to get there and it isnt finished, the fuel pump still needs some lovin you can see at the end of the graph how it was maxed out. sorry for the bad pic.

stock eaton, inj, maf, and pulley, jlt cold air, catless h, flowmasters ran about 7.5psi

http://i37.photobucket.com/albums/e91/Turborust/dyno.jpg

[TR04MACH]

Nice numbers! We've got all kinds of eaton swapped machs running around lately.

[Derek]

this was done on stock ex manifolds and only saw about 7.5 psi

[got03mach1]

Must be full as hell to drive, i really wanted to do the swap since i have complete 03 cobra motor sitting here. But i guess i just dont wanna take the risk of blowing my motor... any vids?

[ZsMach]

How much did the entire swap cost you? Is there a big difference in how much gas you are using up now? :worship: Like got03mach1 said, vids would be awsome. Congrats on the numbers :)

[Derek]

i had about alot with the tune and new jlt intake.. that being said I got a killer deal on all the partsminus injectors,maf, and cai from a local guy going TT on his cobra. No vids of the dyno but i'm going to the track friday and i'll have some vids.

[Derek]

Must be full as hell to drive, i really wanted to do the swap since i have complete 03 cobra motor sitting here. But i guess i just dont wanna take the risk of blowing my motor... any vids?

put the whole motor in sell your stocker and profit..

[Derek]

fixed fuel and tonight it made 442 and 395 tq with over 380tq at 2k rpms. going to the track friday, shooting for 11.25@120mph.

[cre8787]

Great #'s. I cant wait to finish mine.