Re: Anyone using a QuickJack??
after spending probably 20 minutes to get the car up and pull all 4 wheels - im done, Im ordering the 7klb set and metal risers from costco. Ive talked to a couple people that have em and love em, spent a bit of time watching youtube videos on em as well.
if do you get them Id look into how people are adding casters to them to roll them around side to side, not just forward and back. Where they place the casters when you start to lift the vehicle the wheels come up off the ground so it's sitting flat like it should.
3 things I gathered from videos
1) make damned sure you unlock both sides when lowering
2) as it says in the book, do NOT stack their rubber blocks
3) there are some better pinch point lift blocks through parent company bendapack if you wont be lifting from welded in subframe connectors or jacking rails
__________________
03 dsg mach1 - MPR built 9.5:1 motor, D1, cams, ported intake, full exhaust, magnum t56, built rear, E85 etc...
'12 F150 FX2 Supercrew with Ecoboost daily beater
|