|
||
|
|
||
05-12-2018, 11:35 AM
|
#1 |
|
Registered User
Join Date: Sep 2016
Location: Milford
Posts: 8
|
H&R SS leaning to the rear
Hey guys, I got some Koni Yellows for my 03 Mach last year. Picked up my H&R Supersport springs with MM Caster/Camber plates. on a flat surface it almost looks as if the rear sits lower than the front. I'm running poly isos front and rear. Anyone have a similar problem or know how to fix said issue?
|
|
|
|
05-13-2018, 12:07 PM
|
#2 |
|
MECHANIC
 
Join Date: Jun 2012
Location: Morgantown, WV
Posts: 916
|
Re: H&R SS leaning to the rear
EAYou can try removing the front isos and just leave the rears in
Or you can play with the clocking of the rear springs (where the tail points |
|
|
|
|
05-14-2018, 04:47 AM
|
#3 |
|
Registered User
 
Join Date: Jan 2004
Location: Grants Pass, Oregon
Posts: 1,777
|
Re: H&R SS leaning to the rear
Or by some MM LCA adjustables & raise the rear a bit.
__________________
I drive a slow Mustang....but I drive it Slow....HARD! |
|
|
|
|
05-14-2018, 07:13 AM
|
#4 |
|
Can't be bridled
 
Join Date: Sep 2007
Location: Texas
Posts: 7,006
|
Re: H&R SS leaning to the rear
I know most don't, but I prefer a slight negative rake...I say leave it
__________________
2004 Mach 1 #6956 5spd w/IUP Eaton swap, longtubes, built 3.73 SRA 452hp/409tq dynojet🏁 |
|
|
|
|
05-15-2018, 02:42 AM
|
#5 |
|
Mach-T
Join Date: Jun 2004
Location: DFW
Posts: 2,865
|
Re: H&R SS leaning to the rear
I know when I ran polys in the front they were pretty thick and seemed to lift the front, I quickly removed them.
__________________
Darrell Black '04 Mach 1 Track Times (bone-stock w/drs):60 ft - 1.90 | 1/8 - 8.67 (100 shot,E85,4:10s,Street tire):60 ft - 1.67 | 1/8 - 7.88 New build - 750rwhp; not track tested (yet) Mods: Build Log Paint&Body Tuned by Manny @ HPP |
|
|
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
<
Linear Mode
