2003-04 Mach 1 Registry Owners Club  


Go Back   2003-04 Mach 1 Registry Owners Club > "GO" Discussions > Engine & Drivetrain (Including trans & rear axles)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-24-2004, 01:00 PM   #11
TheWaterSkier
Registered User
 
TheWaterSkier's Avatar
 
Join Date: Feb 2004
Location: Lake Worth, FL
Posts: 481
Quote:
Originally posted by Mach1Canuck
Does it stay at 1800rpm? Or does it fall down then rise back up to 1800?

Not exactly sure, but I think that's close to the starting speed.

The Mach1 starts at the speed. That is the speed that the starter turns the motor at to start the engine. Determined by Ford to be the lowest speed that the engine will remain idling/running under all starting conditions....

Doubt it... typical cranking speed of modern V8 engines is around 150rpms....
__________________
Roger

Traded on another vehicle. The Mach was a great car with very few issues in the 93,000 miles I put on it. I'll miss it...

'04 DSG 5 Spd. IUP
Tri-Ax purchased day before Mach, installed day of purchase. MGW Adjustable Shifter Arm.
Borla Stainless Steel "Stinger" Cat-back. Fiore firewall adjuster/Steeda clutch quadrant.
TheWaterSkier is offline   Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:38 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
(c) 2002-2013 Mach1Registry.com

<