|
07-27-2017, 11:32 AM | #1 |
700 HP Mach
Join Date: Nov 2003
Location: Orlando, FL
Posts: 8,384
|
knock sensor wiring diagram - anyone have it?
i need to tap into the positive wire for the factory knock sensor for my J&S Vampire but want to verify the pin# and color. The instructions suggest pin 57 and yellow with a red stripe but apparently that may be wrong.
the factory service manual I acquired doesnt have the electrical stuff in it.
__________________
03 dsg mach1 - MPR built 9.5:1 motor, D1, cams, ported intake, full exhaust, magnum t56, built rear, E85 etc... '12 F150 FX2 Supercrew with Ecoboost daily beater |
07-27-2017, 11:53 AM | #2 |
Can't be bridled
Join Date: Sep 2007
Location: Texas
Posts: 7,006
|
Re: knock sensor wiring diagram - anyone have it?
__________________
2004 Mach 1 #6956 5spd w/IUP Eaton swap, longtubes, built 3.73 SRA 452hp/409tq dynojet🏁 |
07-27-2017, 01:22 PM | #3 |
700 HP Mach
Join Date: Nov 2003
Location: Orlando, FL
Posts: 8,384
|
Re: knock sensor wiring diagram - anyone have it?
cool but yikes, im quite sure I can dig it up for free lol. Somebody is dropboxing me some stuff now.
__________________
03 dsg mach1 - MPR built 9.5:1 motor, D1, cams, ported intake, full exhaust, magnum t56, built rear, E85 etc... '12 F150 FX2 Supercrew with Ecoboost daily beater |
07-27-2017, 03:29 PM | #4 |
700 HP Mach
Join Date: Nov 2003
Location: Orlando, FL
Posts: 8,384
|
Re: knock sensor wiring diagram - anyone have it?
http://www.moddedmustangs.com/forums...-mach-1-a.html
post 4 has pintouts for 03 PCMs. pin 57 orange w/ red pin 102 is green/violet theres 2 knock sensors, one wire for each
__________________
03 dsg mach1 - MPR built 9.5:1 motor, D1, cams, ported intake, full exhaust, magnum t56, built rear, E85 etc... '12 F150 FX2 Supercrew with Ecoboost daily beater |
07-27-2017, 05:40 PM | #5 |
Can't be bridled
Join Date: Sep 2007
Location: Texas
Posts: 7,006
|
Re: knock sensor wiring diagram - anyone have it?
Free is good! Glad you found it.
__________________
2004 Mach 1 #6956 5spd w/IUP Eaton swap, longtubes, built 3.73 SRA 452hp/409tq dynojet🏁 |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|