Phenolic Intake Spacers Are Here

[Roy]

[THEONE1]

put on my 1/2 inch phenolic spacer today.... wasnt very hard except for the egr.. i took a little different approach with it though.. i actually unscrewed the pipe comming out of the egr instead of removing the actual egr... it seemed like a good idea... but it was hard enough to get the pipe back in.. because its not exactly long enough... even after i got it back in, it was in at an angle so i could start the threading... so here's what i did... i unscrewed only the back screw on the actual egr and tilted it back a bit so i could screw the pipe back in.. then tightened the pipe and put a pry bar under the pipe to lift the back end of the egr up enough for me to put the back screw back in.. i wish it wouldnt have take me like an hour to figure it out .. lol but maybe i can save someone else some time.. i will report back after i test out the performance of my car on the open road... i just washed it so i've been riding low and slow...

[Matress22]

Hey Roy I am new to the fourm and was looking at the intake spacers you make. Was wondering if you could give me a price on the 1/2" spacer kit, shipped to Ontario, Canada, L0G1A0. Thx

[Roy]

I dont make phenolic spacers any more. Just aluminum.