TTSaleen's Eaton Swap Mach 1 project

[TTSaleen]

This will be my thread to capture the start of my Eaton swap onto my 2003 Mach 1.

I purchased a complete take-off kit from svtp website off a guy with a 2003 Cobra. My kit has a Steggy stage 4 ported Eaton, LFP single blade throttle body, AFCO single stage heat exchanger, plus all the little parts including cables, brackets, hoses, etc.

Over Christmas break, I installed front heat exchanger, lines and water pump/bracket.







Sunday, January 4th, 2015 -
Started the disassembly of my Mach 1.

Removed hood and front bumper.

Started removing shaker, alternator, power steering, coil covers, mass air, vacuum lines, etc.
Drained radiator and removed hoses and thermostat.

Spent about 2 hours on it taking my time to label everything and put small parts in ziplock bags.






My plan is to take this project slowly and address small details to ensure it not only works properly, but looks good doing it!