2003-04 Mach 1 Registry Owners Club  


Go Back   2003-04 Mach 1 Registry Owners Club > General Discussions > Regional Area Forums > US-SouthEast Region

US-SouthEast Region TN, NC, SC, GA, FL, AL, MS, AR, LA

Reply
 
Thread Tools Display Modes
Old 02-16-2011, 03:09 PM   #1
THEE HAMMER
Registered User
 
THEE HAMMER's Avatar
 
Join Date: Feb 2011
Location: Dunn, NC
Posts: 32
NC mach owners?

How many of you guys on here?
Where are you hiding at?
Are you members of any local clubs?
Go to any shows? Or cruises?


I'd like to meet up with a few guys on a weekend if possible. When I had my s2000 there were cruises every month in fayetteville and Raleigh... we usually left and pestered the Ferrari and Porsche Clubs lol.

I live in Erwin in the middle of the state so i'm not too far from anywhere.

So yea.....
THEE HAMMER is offline   Reply With Quote
Old 02-22-2011, 11:16 PM   #2
nh70744
Registered User
 
nh70744's Avatar
 
Join Date: Aug 2009
Location: West Jefferson, NC
Posts: 112
Re: NC mach owners?

Live near Boone, NC so I'm obviously on the western end of the state. I'd be down to meet up some nice weekend. Hickory, Winston, etc. those places are bout an hour and a half from me, not too bad of a drive. Gas ain't cheap, but I'm bored
__________________
Appalachian State University class of 2009
nh70744 is offline   Reply With Quote
Old 02-22-2011, 11:48 PM   #3
THEE HAMMER
Registered User
 
THEE HAMMER's Avatar
 
Join Date: Feb 2011
Location: Dunn, NC
Posts: 32
Re: NC mach owners?

Quote:
Originally Posted by nh70744 View Post
Live near Boone, NC so I'm obviously on the western end of the state. I'd be down to meet up some nice weekend. Hickory, Winston, etc. those places are bout an hour and a half from me, not too bad of a drive. Gas ain't cheap, but I'm bored
Yea boredom sucks lol. Boone is a nice area, a bit more scenic than here in the foothills.

Finally rand into another mach type car at the strip last week. Was a 2004 gt convertible converted with mach hood and shaker, mach rims (deep dish rear) stripes, and the Mach blue finish. Ran a 9.2 my first time. The Harnett co. mustang club was in attendance so it was quite nice.
I'd love to extend an invitation to all members here to join us at Dunn/Benson Drag strip thursday nights (test and tune) $10 to run em unlimited from 5-10pm.
THEE HAMMER is offline   Reply With Quote
Old 02-23-2011, 12:08 AM   #4
rich1
AUTOMACHTIC
 
rich1's Avatar
 
Join Date: Oct 2007
Location: RTP/ N.C.
Posts: 4,813
Re: NC mach owners?

Rockingham...Real men run the 1/4 not the 1/8 !
__________________
UPGRADES...Tokico Illuminas Borla SS Catback , Steeda Underdrives , Strut Brace , HPM Lower K Brace , L /C Arms , U /C Arms , HPM PanHard Bar, K&N FRPK 2, GOODYEAR GT1 , MRT- H-Pipe , JLT VaporTraps , SLP-12'" Tips! , FRPP Shorty 1 5/8 Headers , Brembo D/S & PBR D/S Rotors ,FRPP Alum.DS ,Roys 3/8 Spacer , SVT Focus 255 pump SCTsw Chip PRO-DYNOjet NA 300.01hp /315tq (Auto) ,Innovate W/B ,Compucar Wet Kit (90jet) + Heater and E Gauge * 360 hp/385tq 12.5 -1/4 @112
rich1 is offline   Reply With Quote
Old 02-23-2011, 10:10 AM   #5
yellowshaker04
Registered User
 
yellowshaker04's Avatar
 
Join Date: Dec 2006
Location: Four Oaks NC
Posts: 461
Re: NC mach owners?

Im in Four Oaks.

If your in Dunn check us out.

www.stangs-r-us.com
__________________
JLT CAI, BBK LT's, BBK OR-H,Flowmasters, Ram clutch, steeda tri ax

309 rwhp, 327tq


You know you have played too much MW2...when.
You instinctively grab your co-workers briefcase, fumble around with it for a few seconds, throw it out the window and yell,"BOMB DEFUSED!
yellowshaker04 is offline   Reply With Quote
Old 02-23-2011, 02:41 PM   #6
THEE HAMMER
Registered User
 
THEE HAMMER's Avatar
 
Join Date: Feb 2011
Location: Dunn, NC
Posts: 32
Re: NC mach owners?

Quote:
Originally Posted by yellowshaker04 View Post
Im in Four Oaks.

If your in Dunn check us out.

www.stangs-r-us.com

Definitely looking to join posthaste, 2 of your members were out there last time but they had no cards
THEE HAMMER is offline   Reply With Quote
Old 02-23-2011, 01:08 PM   #7
THEE HAMMER
Registered User
 
THEE HAMMER's Avatar
 
Join Date: Feb 2011
Location: Dunn, NC
Posts: 32
Re: NC mach owners?

Quote:
Originally Posted by rich1 View Post
Rockingham...Real men run the 1/4 not the 1/8 !

I Used to run my Supra at Freaky Fridays at Fayetteville's 1/4.

You can bet your @$$ my favorite strip in the state is rockingham.
THEE HAMMER is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:59 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
(c) 2002-2013 Mach1Registry.com

<