|
04-19-2007, 06:02 PM | #1 |
Registered User
Join Date: Oct 2006
Location: Owasso, OK
Posts: 297
|
CD 6 Player Problems - $90.00 Solution
After the third f*cking radio I bought on eBay - One the wrong spec., another the wrong radio entirely (used a Mach 1 interior shot for his listing) and the third with a D.O.A. CD player, I finally gave up and went searching for an OEM car audio repair shop. These guys know exactly what's need to fix your CD player.
They quoted me around $90 if I sent in my CD player only, so here's some tips on seperating the faceplate and radio/ CD player. -Obtain a T08 and a T10 Torx bits (these are small! Radio Shack carries them in a kit) -Pull on the volume knob, it pops right off -Remove the faceplate (4 countersunk screws, carefully pop it over the 4 tabs), disconnect the small 2 pin plug -If you want, this is a good time to clean your faceplate. Remove the circuit board by removing the gold screws and lift it out. I washed mine with mild detergent and a paint brush, rinse and blow dry with compressed air. It's just plastic at this point, allow to air dry completely. -The CD player is held on with side screws, pretty self-explanatory. This is what you need to send off...http://www.rivetech.com/Fordmech.html Home page...http://www.rivetech.com/
__________________
`03 Torch Red Mach |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|