|
|
Accessories - Non Performance type add-ons Found any cool accessories for your Mach 1? NON Performance add-ons. |
|
Thread Tools | Display Modes |
08-18-2012, 09:38 PM | #101 |
WNTAMACH1
Join Date: Dec 2008
Location: New Orleans, LA
Posts: 2,394
|
Re: Auto Meter Electric Water Temp & Oil psi Gauge Installed
Waking the dead. What size 90 degree elbow will I need for my oil pressure gauge install? Also what is best to seal the threads? Tape or loctite? Need help ASAP!
__________________
2004 Ford Mustang Mach 1-315 RWHP/ 336 RWTQ 2013 Ford Mustang GT 5.0 Auto- 421/406 SOLD 2013 Ford Taurus SHO PP - Daily Driver |
08-20-2012, 01:25 PM | #102 |
WNTAMACH1
Join Date: Dec 2008
Location: New Orleans, LA
Posts: 2,394
|
Re: Auto Meter Electric Water Temp & Oil psi Gauge Installed
Installed!
__________________
2004 Ford Mustang Mach 1-315 RWHP/ 336 RWTQ 2013 Ford Mustang GT 5.0 Auto- 421/406 SOLD 2013 Ford Taurus SHO PP - Daily Driver |
09-17-2013, 02:47 PM | #103 |
Registered User
Join Date: Jul 2009
Location: Santa Rosa, CA
Posts: 857
|
Re: Auto Meter Electric Water Temp & Oil psi Gauge Installed
Great write up. Helped a lot.
|
09-28-2013, 10:00 PM | #104 |
Hillclimb Extraodinaire
Join Date: Aug 2004
Location: Perkiomenville, PA
Posts: 2,594
|
Re: Auto Meter Electric Water Temp & Oil psi Gauge Installed
Well, it was too hard to see the oil pressure and water temp gauges when in the pod. I had mechanicals but decided it was easier to see a number than a needle position. So, I moved them.
L to R Water temp (out of the head cooling mod fitting in the back of the pass head) Oil pressure (off the exit side of the remote oil filter) Tach AFR (driver's side collector) Voltage (pump voltage just before the pump) Car still warming up. Otherwise, idle is 770.
__________________
RIP - Destroyed August 15, 2015 Motor + Procharger + driver = Baddest hillclimbing Mach 1 in the country Mustang dyno: 538hp/481tq @ 14lbs/19deg timing DynoJet comparison: 600hp/539tq Looking for more hillclimbers! |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|