|
||
|
|
||
12-07-2009, 05:18 PM
|
#1 |
|
Registered User
 
Join Date: Nov 2009
Location: Chester County, PA
Posts: 330
|
Accufab throttle sticking
My brothers Mach recently had an accufab tb installed and now whenever he stops the car will rev by itself until he either shuts the car off or steps on the accelerator. What can I do to fix this??
|
|
|
|
12-07-2009, 10:47 PM
|
#2 |
|
Can't be bridled
 
Join Date: Sep 2007
Location: Texas
Posts: 7,006
|
Re: Accufab throttle sticking
you can use the search feature in this forum to answer your question about aftermarket tb's.
__________________
2004 Mach 1 #6956 5spd w/IUP Eaton swap, longtubes, built 3.73 SRA 452hp/409tq dynojet🏁 |
|
|
|
|
12-07-2009, 11:20 PM
|
#3 |
|
not builted
 
Join Date: Feb 2009
Location: perry ga
Posts: 1,183
|
Re: Accufab throttle sticking
not sure how they do the butterfly on those but on my old edelbrock on y turbo honda it had screws in it. when it would stick i would take it off, loosen the screws a bit, open it then let it slam shut, then just tighten the screws back up. thi sworked every time for about 4 months then i would have to do it again. hope this helps.
__________________
2004 Torch Red Mach 1 - C&L cai, Kooks longtubes, Kooks o/r x-pipe, Magnaflow Magnapacks, Roy's 1/2" spacer, FRPP aluminum d/s, FRPP 4.10's, FRPP billet F/W, Ram HDX, MGW orange handle, H&R Super Sports |
|
|
|
|
12-07-2009, 11:24 PM
|
#4 | |
|
AUTOMACHTIC
Join Date: Oct 2007
Location: RTP/ N.C.
Posts: 4,813
|
Re: Accufab throttle sticking
Quote:
 But people keep taking them out of the trash cans and selling or using them !
__________________
UPGRADES...Tokico Illuminas Borla SS Catback , Steeda Underdrives , Strut Brace , HPM Lower K Brace , L /C Arms , U /C Arms , HPM PanHard Bar, K&N FRPK 2, GOODYEAR GT1 , MRT- H-Pipe , JLT VaporTraps , SLP-12'" Tips! , FRPP Shorty 1 5/8 Headers , Brembo D/S & PBR D/S Rotors ,FRPP Alum.DS ,Roys 3/8 Spacer , SVT Focus 255 pump SCTsw Chip PRO-DYNOjet NA 300.01hp /315tq (Auto) ,Innovate W/B ,Compucar Wet Kit (90jet) + Heater and E Gauge * 360 hp/385tq  12.5 -1/4 @112
|
|
|
|
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
<
Linear Mode
