|
|
Accessories - Non Performance type add-ons Found any cool accessories for your Mach 1? NON Performance add-ons. |
|
Thread Tools | Display Modes |
04-08-2013, 11:21 PM | #1 |
700 HP Mach
Join Date: Nov 2003
Location: Orlando, FL
Posts: 8,384
|
putting the "32 valve V8" badge back on the coil cover?
any thoughts of an adhesive to use for this?
I took my plate off before sending everything to the powder coater, I figured Id just use some of the 3M double sided body tape but it raises it up a little more than Id like. Im thinking something liquid/gel based that could take the heat would be the best solution, then I can make sure the corners are stuck down well and just wipe off whatever squeezes out from underneath
__________________
03 dsg mach1 - MPR built 9.5:1 motor, D1, cams, ported intake, full exhaust, magnum t56, built rear, E85 etc... '12 F150 FX2 Supercrew with Ecoboost daily beater |
04-09-2013, 12:11 AM | #2 | |
Registered User
Join Date: Dec 2012
Location: Crockett, Ca
Posts: 289
|
Re: putting the "32 valve V8" badge back on the coil cover?
Quote:
|
|
04-09-2013, 12:14 AM | #3 |
Registered User
Join Date: Aug 2011
Location: Absecon,NJ
Posts: 225
|
Re: putting the "32 valve V8" badge back on the coil cover?
i was gonna say high temp silicone or high temp metal epoxy like this
http://gokimco.com/loctite-83104-hys...FUZN4AodUWoAFA |
04-09-2013, 08:25 AM | #4 |
700 HP Mach
Join Date: Nov 2003
Location: Orlando, FL
Posts: 8,384
|
Re: putting the "32 valve V8" badge back on the coil cover?
i think the high temp silicone might be a winner, hadnt even thought of it being able to take the heat but I was just thinking about the clear stuff. Dont wanna use Epoxy incase it ever needs to come off again
__________________
03 dsg mach1 - MPR built 9.5:1 motor, D1, cams, ported intake, full exhaust, magnum t56, built rear, E85 etc... '12 F150 FX2 Supercrew with Ecoboost daily beater |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|