2003-04 Mach 1 Registry Owners Club - View Single Post

SuperMach1 · 12-13-2013, 02:02 PM

[QUO TE =Mach828;1568135]I'd pay to have the heads looked at. A friend of mine trusted a used set of heads that ended up costing him a motor and eventually had to sell his car because of the added expense.

Sent with a shot of DROID go fast[/QUOTE]

the heads are at the shop right now getting freshened up. when I showed him the heads I asked if he thought they're Livernois and he said there's a Good chance they could be. He really liked the ports and since they were used we went ahead and ordered oversize SS valves, did a 4 angle valve job, and new seals.

12-13-2013, 02:02 PM	#41
SuperMach1 Never Satisfied Join Date: Sep 2007 Location: San Antonio, TX Posts: 1,134	Re: Starting my Build [QUO TE =Mach828;1568135]I'd pay to have the heads looked at. A friend of mine trusted a used set of heads that ended up costing him a motor and eventually had to sell his car because of the added expense. Sent with a shot of DROID go fast[/QUOTE] the heads are at the shop right now getting freshened up. when I showed him the heads I asked if he thought they're Livernois and he said there's a Good chance they could be. He really liked the ports and since they were used we went ahead and ordered oversize SS valves, did a 4 angle valve job, and new seals. __________________ P1 8psi @ 6k PA Transmission DD 3,600 Stall BBK LT's w/ 3in Collector Custom 3in X-Pipe Custom 3in CB w/ Pypes 3in M-80's Built Rear w/ 4:10 415/383 PB 11.80, @ 119 with a 1.71 60ft Tuned by http://www.southtexasperformance.com/ Built WAP Block, 10.5:1 compression, 14psi, E-85 Coming soon.