Quote:
Originally Posted by DSG2003Mach1
its pretty common for part numbers to change over time, I can't recall a Ford oem shaker setup on anything else, can't imagine it would be a different number.
unless its seriously drooping a 3" gap is huge, some pictures of your setup might help figure out whats going on. You don't have a k-member or engine mounts for lowering a motor do you?
|
Good afternoon,
Yep, have a UPR K frame with polyurethane engine mounts, the bezel I have never fit tight against the drivers side corner, was outside before and took off the bezel to see where it might be hitting, took off the hood insulated as well, that drivers corner will not fit flush, didn’t know if there’s a technique to this, darn pics won’t upload