Thread: Eaton Swap.....
View Single Post
Old 06-22-2018, 12:25 PM   #787
MachRyan
Registered User
 
Join Date: Nov 2017
Location: IL
Posts: 21
Re: Eaton Swap.....

The Eaton that I'll be running is from a Cobra that had it ported/polished - with a stock bottom end in my Mach, what benefit if any will I be able to see in having this? Also, I'd like to know if most of you are running the stock sized upper/lower pulley's or what you've done with your setups.

Thanks in advance.
MachRyan is offline   Reply With Quote