Thread: Eaton Swap.....
View Single Post
Old 01-17-2011, 04:46 PM   #498
Mudd92
03 Mach
 
Mudd92's Avatar
 
Join Date: Jan 2009
Location: Savannah, GA
Posts: 1,396
Re: Eaton Swap.....

Stock lower, they are coming from ford but there all remans, even when I ask for new. I put a 3.2 pulley on this one I put on sunday, drove it all day, did great, at WOT above 5k i was for the first timing keeping over 13.5V. but I got in it and fired it up last night to go home from a buddies and it was spiking 16v. I ran every acc. on high and could be easy on the rpm's and keep it below 15 barely. Boiled the battery over some but i made it home without frying anything as far as i could tell.

Im going to double check I got the power wire good n tight but I got another one under warranty. The one that died before this lasted about 6 months.


I dont see what could be going wrong??? I dont think there getting wet, maybe a little moist in the rain but i dont hose it down or anything
__________________
-03 AB Mach 5spd
Accufab TB, BBK LT's, BBK O/R X, Mac Catback, JLT RAI, 98 Cobra intake cams, EBC redstuff pads, slotted drilled rotors, 31 spline mosers, 31 spline cobra posi, 3" studs, FRPP 3:73, welded tubes, smoked tails. Eaton swap! 465hp,425tq @ 15deg and 3.4pulley @ 10lb. T56 magnum! - Tuned by Eric Brooks! Built motor coming soon

-95 Chevy C1500 5.7 auto
Stock, tow rig and DD.

-Joey
Mudd92 is offline   Reply With Quote