2003-04 Mach 1 Registry Owners Club - View Single Post - putting the "32 valve V8" badge back on the coil cover?

DSG2003Mach1 · 04-08-2013, 11:21 PM

any thoughts of an adhesive to use for this?

I took my plate off before sending everything to the powder coater, I figured Id just use some of the 3M double sided body tape but it raises it up a little more than Id like.

Im thinking something liquid/gel based that could take the heat would be the best solution, then I can make sure the corners are stuck down well and just wipe off whatever squeezes out from underneath

04-08-2013, 11:21 PM	#1
DSG2003Mach1 700 HP Mach Join Date: Nov 2003 Location: Orlando, FL Posts: 8,384	putting the "32 valve V8" badge back on the coil cover? any thoughts of an adhesive to use for this? I took my plate off before sending everything to the powder coater, I figured Id just use some of the 3M double sided body tape but it raises it up a little more than Id like. Im thinking something liquid/gel based that could take the heat would be the best solution, then I can make sure the corners are stuck down well and just wipe off whatever squeezes out from underneath __________________ 03 dsg mach1 - MPR built 9.5:1 motor, D1, cams, ported intake, full exhaust, magnum t56, built rear, E85 etc... '12 F150 FX2 Supercrew with Ecoboost daily beater