Woof... okay, so I finally got the manifolds in (took a while because I ended up needing someone to help hold) hooked the X-pipe back up, installed the starter, A/C compressor, and P/S pump. Now, I'm to the point where I can start hooking connections back up, and hopefully get this thing started before Christmas!
I'll certainly be needing your guy's help though as I don't remember how any of the wire looms were routed, where the throttle cables were ran, or where a few of these leftover bolts go haha.
So here's where we sit as of this morning. My first question is these knock sensors. I've been told that they're different between a Mark VIII and a Mach 1. Do I need to swap sensors, or harness connectors?
