Thread: Eaton Swap.....
View Single Post
Old 07-06-2012, 10:16 AM   #574
machgsxr
Registered User
 
machgsxr's Avatar
 
Join Date: Feb 2005
Location: San Antonio
Posts: 6,414
Re: Eaton Swap.....

Quote:
Originally Posted by Kove View Post
You don't have to get the Cobra IAC but it is recommended because of the way our stock ones wiring harness points to the hood instead of to the side. For the IAT2, you can use either the IAT sensor in the intake or the IAT2 at the back of the blower. Our wiring harness doesn't have the provisions for both.


Sent from my iPhone using Tapatalk
Since you have an 01, I think they have a separate iat sensor already. You can use that one or just extend the wires to the iat2, which would be preferred for most. If you use the stock one you will still need the iat2 sensor to plug the hole in the blower.

For iac you can user the stock one, but you will have to put it in a vice and turn it 90 degrees so that it points to the side.

Yes, the 01s still have the knock sensors in the valley.
machgsxr is offline   Reply With Quote