View Single Post
Old 12-07-2004, 04:14 PM   #1
03Steve
Registered User
 
03Steve's Avatar
 
Join Date: Dec 2004
Location: St. Louis, MO
Posts: 298
How to change your 5 speed to an automatic

Here is it, in plain english when possible.
Think this about everything, minus the tranny and converter.
I will add as I remember. This will acheive a stock looking
automatic Mach 1:

1R3Z-7210-AA - Shifter assembly: $174.42
XR3Z-7E395-AA - Trans shift cable assy: $48.24
F6SZ-7007-A - Lower bellhousing cover: $32.47
XR32-7C078-BA - 4R70W wiring harness: $90.00
XR3Z-7B229-AA - Brkt-trans kickdown cable: $9.80
3R3Z-6304567-AAB - Bezel out of Mach 1, I traded for charcoal gray: $170.22
1R3Z-4841-EA - 4R70W driveshaft yoke for tranny tailshaft: $85.38
F1VY-7986-A - ***-Will post desciption up later: $5.70
F8AZ-7G276-AA - Shifter position sensor: $22.27
F6ZZ-3F719-AC - Cable asy-ign shift interlock: $57.18
E43Z-7B415-A - Stud-tr gr sh conn rod adj: $6.18
F1DZ-7H181-A - Fitting-trans shft actu ca: $7.68
1L3Z-7H103-AB - Speed sensor: $22.31
XR3Z-7A228-BA - Fill tube for tranny fluid: $15.83
XR3Z-7A020-BA - Dip stick for fill tube: $19.37
378377-S - Plug button for firewall hole 1.38 dia: $1.91
F2UZ-7H183-A - Plug for the mechanical speed sensor - if not supplied with transmission



Also need:

-8 bolt flexplate. I got mine from Perfomance Automatic for $226.00
-Plug for convertor/flexplate access port on bottom of bellhousing, Ford $4.00
-GT automatic brake pedal, Ford $30.00
-Mach 1 brake pedal cover, Ford $32.00
-B&M 24,000 GVW tranny cooler, Summit $48.00
-Tranny cooler lines and fittings, Auto Zone $40.00
-Switch for overdrive to replace coin holder, Strictly Pro $10.00
-1350 to 1330 u-joint for tailshaft yoke, Auto Zone $30.00
-11/16 driveshaft spacer from Steeda, $20.00










Questions:

Steve
(314) 409-6731
__________________
2003 Cobra Coupe SOLD
WFC8 #7 Heads Up Qualifier - Cobra Eliminator
MSC3 #1 Heads Up Qualifier - Fastest Ford Vehicle

Saleen Clone CURRENT
-10.7:1 Compression and 2.3L Whipple
-Comp Cams 106360 cams @ 108LSA
-4R70W and CVAF1 Auto EEC
-96 Cobra Rear End
-Machine/Head work by Todd Fays of Phase 2 Crestwood, MO

http://i79.photobucket.com/albums/j1...unch2small.jpg
03Steve is offline   Reply With Quote