|
Re: Front brake replacement planning
Quote:
Originally Posted by 32VALVR
Do not buy Rotorpros. I had them and it felt like my foot was right on the rotor. 200Cobra R if you can find them. Brembo four piston, also fancy drilled rotors are just for looks. Nice cheap untouched cast iron works the best.
|
Sup Dave! What exactly was wrong with your rotors? My slotted ones from rotorpros have worked well for about 25k miles with hawk hps and stoptech street pads biting at them. I can feel the slots in the pedal sometimes, depending on how much pressure I apply, but I only feel it below 20mph. I can image this has to be typical for a slotted piece. I make the trade for a bit of performance and styling. Can't argue with the Cobra R setup though, which is slotted as well. May eventually do something like that.
__________________
2004 Mach 1 #6956 5spd w/IUP
Eaton swap, longtubes, built 3.73 SRA
452hp/409tq dynojet🏁
|