|
Re: Hanging/Slow dropping RPM FIX inside.
Quote:
Originally Posted by jjm525
I'm using the NC plate and still get a hanging idle 50% of the time at around 1400, takes more than a few seconds to drop to normal when it does. Is there a real fix for this? My last Mach got the plate and it just worked great, idle dropped fast & hard. tThis one still seems to float even when it drops.
Thanks.
|
Keep trying a smaller hole would be my advice. You might even have to go to just one hole instead of two like I did.
__________________
2004 Mach 1 Azure Blue
Built 5.0L stroker
P1SC w/ supporting mods
Promotion 3650 with McLeod RXT clutch/flywheel
31 spline rear end w/ 3.73's
JBA shorty headers, Magnaflow catted x-pipe, Borla Stingers
|