Quote:
Originally posted by sharp4.6
Not wanting to put any more stress on the plastic studs, by putting more washers under that side I raised the ball stud plate with 3 ss washers under the front bolt, between the alum. mounting bracket and the ball stud plate, and a large thick washer under the flat thick adjustment plate.
|
I, too, had thought about raising the entire main plate instead of just unscrewing each ball stud. Though, instead of using washers, I thought about using body shims. These are "U" shaped, and can be inserted between the main plate and the front/rear mounting brackets by just loosening the bolts (instead of having to completely remove the bolts as washers would require).