|
Re: Installing Manual Fan Override Switch
OK. Got it done. It was pretty easy. Hawk verified that the instructions was talking about the correct wire. His notes below:
"OK, I checked out the schematic for ours, and yes, the wire you want is the Light green with violet stripe, coming off pin 46 of the main PCM connector (C175).
Grounding that wire will engage the high speed fan relay regardless of the PCM signal. So wire a switch from that lead to ground.
You can turn the switch "on" and the fan will run at high speed as long as the ignition is turned to "run". If the switch is "off", the PCM again controls the fan."
It runs just like he says.
__________________
2003 slowmatic  11.105@117mph w/125 shot of Nitrous best to date
Kooks LTsw/OR X, elect cutouts, JLT RAI w/C&L 85 MAH,1" Spacer,PP Lower intake,Accufab TB,160 T-stat,EF Cooling Mod,NX Kit,Mez Electric Water pump,SLP Linelock,FRPP 4.10s-Alum Dif Cover-Alum Driveshaft & SL, Steeda Bumpsteer,MM Alum rack bushings,Deep Alum Tranny pan,Predator,Steeda AUCAs,MM ALCAs, Dspecs,MM CC plates & FLSFCs,MRT Guage cluster,AEM WB,MRT hood struts,Seq TLs, carbon fiber hood/trunk/Cobra wing,220 amp alt
|