(5/1/09) Price drop $26,500
PRICE DROP - $26,500 with the wheels or $24,500 if you provide your own. Now has 9900 miles.
www.tampaftp.com/jeff/machsounds.wmv
Notice the parts selection here - all the nicest stuff.
Torch Red 03 Mach 1 $31k
9600 miles
Engine
Built Teksid shortblock
Cobra Crank
CP 17cc Pistons
ARP Head and Main Studs
Canton AL road race pan, Canton windage tray
Comp Springs and Retainers
Ford GT cams
140AX 2.3 Whipple
Metco 6# lower
Billetflow 4-piece idler kit
Powder-coating on valve covers, timing covers and front acc.
Accufab TB
JLT Big Boost CAI
LFP Heat Exchanger
Maximum Motorsports oil-filter relocation kit
Fuel/Tuning
SCT BA2400
60lb Injectors
Cobra Tank
Cobra Pickup with Ford GT pumps
Dual FPDM harness
Livewire SCT tuner
Innovate LC1 wideband
3-bar MAP (both wideband and MAP connected and working through Livewire - can datalog both)
Exhaust
American Racing Longtube Step-Headers 3" Merge Collectors
Custom 3" X-pipe w/V-Band clamps at collectors
SLP LM1 Stainless Cat-Back
Drivetrain
2000 Cobra-R Spec T-56
26-spline Input Shaft
Ram HDT clutch
Dynotech Aluminum Driveshaft
Suspension
Maximum Motorsports K-member
Maximum Motorsports Control arms
Maximum Motorsports Coil-overs
Maximum Motorsports Caster-Camber plates
Maximum Motorsports Swaybar relocation kit
Bilstein Struts and shocks
Steeda sway-bar
Steeda rear adj. alum lowers
Steeda double-adjustable uppers
Wheels/Tires
18inch Forgeline GT3 wheels (18x10.5, 18x9)
New pzero rosso tires (315/30/18 - 265/35/18) - Wheels/tires over $4k alone.
Basically, it has everything that even a Cobra could aspire to have. I installed the cobra accessory/supercharger drive parts as well - so this is exactly like a modded Cobra under the hood. All supporting mods EXCEPT the only thing I haven't done is change the rear axles - and I would suggest it for sticky tires...which are required to even think about getting it to hook in anything lower than 4th gear.
Pics:
http://tampaftp.com/jeff/machpics%20001.jpg
http://tampaftp.com/jeff/enginerun%20036.jpg
^^ Shaker is now installed
http://tampaftp.com/jeff/machpics%20005.jpg
Here's one that someone else took at a local car show:
http://i134.photobucket.com/albums/q...g?t=1206493246
There are also a few more pics of the same event from different angles:
http://s134.photobucket.com/albums/q...xa/QSL%20Meet/
Strangly enough, I cant find any engine shots that I took once it was finished. They might be on the wifes laptop still. There are a few pictures in the following thread of the engine in the K-member, before install and of the engine a few minutes after it was installed
It looks perfectly at home now
http://mach1registry.org/forums/showthread.php?t=70334
More Pics:
http://tampaftp.com/jeff/IMG_2053m.jpg
http://tampaftp.com/jeff/IMG_2064.JPG
http://tampaftp.com/jeff/IMG_2043.JPG