View Single Post
Old 02-06-2018, 12:57 AM   #21
rich1
AUTOMACHTIC
 
rich1's Avatar
 
Join Date: Oct 2007
Location: RTP/ N.C.
Posts: 4,806
Re: Got a deal on a 2016 Prem GT

I bought a GT 350 intake kit and going to use the Roush cold air kit with the 105 mm Mass air( Stock is 85mm). The stock 80mm throttle body will be used since the larger 87 mm does not add any hp and surges according to Pro-Dyno. Properly set up this will add 35hp across the board and giving a total peak of 55 hp @7500 rpm ,That's 490hp flywheel with auto trans. ,Long tube headers if installed will bring it up to 500hp +.
I decided not to buy the Ford Racing kit because the tune they provide is too lean(spark knocks) and does not use the knock sensors stated Dan at Pro Dyno .
__________________
UPGRADES... Borla SS Catback , Steeda Underdrives , Steeda Strut Brace , HPM Lower K Brace , L /C Arms , U /C Arms , HPM PanHard Bar, K&N FRPK 2, GOODYEAR GT1 , MRT- H-Pipe , JLT VaporTraps , SLP-12'" Tips! , FRPP Shorty 1 5/8 Headers , Brembo D/S & PBR D/S Rotors ,FRPP Alum.DS ,Roys 3/8 Spacer , SVT Focus 255 pump SCTsw Chip PRO-DYNOjet NA 300.01hp /315tq (Auto) ,Innovate W/B ,Compucar Wet Kit (90jet) + Heater and E Gauge * 360 hp/385tq 12.5 -1/4 @112

Last edited by rich1; 02-07-2018 at 12:22 AM.
rich1 is offline   Reply With Quote