View Single Post
Old 11-04-2017, 12:19 PM   #10
Machwon Jerry
Registered User
 
Machwon Jerry's Avatar
 
Join Date: Oct 2017
Location: Jacksonville, Florida
Posts: 25
Re: Intake Spacer Dyno Results

Okay guys sorry i haven't responded sooner runs were done in order 3,4,5, and 6 so there was no real power gain. I think run 3 was just garbage and my tuner didn't pull hard or something. Runs 3 and 4 were done with 301 Eagle stroker kit 9.1:1 compression, pocket port on the heads, comp cams 106100s w/ beehive springs and Comp cam gears, MAC LTs and O/R Prochamber w/ stock catback and a K&N CAI. Runs 5 and 6 were w/ same mods except i put the spacer on while the car was cooling down. All runs were same day. My A/F did go from about 12.5-12.8 all the way up to over 14. I think as far as Hp goes its not worth it, but it does make the shaker look better. I also put 2 nuts under the front part of the shaker bracket to level it out after. I am wondering what would happen if we change the tune up a little and give it some more fuel.
__________________
-Eagle 301 stroker kit
-Pocket ported heads
-Comp Cams 106100s
-Roy's 3/8" Intake Spacer
-K&N CAI
-Full MAC exhaust
-Steeda UDPs
-Steeda Tri-ax shifter
-Exedy Stage 2 clutch
-Exedy flywheel
Machwon Jerry is offline   Reply With Quote