Re: Intake spacer... again
ICT billet installed. Before I started I noticed the new gasket I bought was broke, but not all the way through. I put a small amount of gray rtv on it and ran it. On a side note I made an iac restrictor plate and installed it at the same time. First start up seemed fine, I went in to wash up and the car died. I restarted it and it would not idle below 1300. Took it for a drive and again wouldn't idle below 1300. Pulled the restrictor plate off and car idles and drives fine. And yes the hardest part was lining up the egr bolts. It looked like the egr gasket was rtv so I put a thin layer on and tightened each bolt a little at a time with anti seize on the bolts. Taking it out of town this evening, I'll post back with results. Btw to early to tell if I gained 3hp or not, lol.
__________________
03 Black beauty 5sp. MGW shifter, JLT ram air, intake spacer, MAC 3” catback, BBK o/r X, Bama tune
92 gt auto, hopefully turbo some day...
2018 f150 sc, 3.5 eco, 10 sp., Guard green
|