Re: Eaton Swap.....
Quote:
Originally Posted by xXAzureMach1Xx
By wiring it that way, the ignition switch will carry all the load from the pump and everything else that it runs. its not meant to run a IC pump. it needs its own fuse also. it will be to much for the ignition switch to handle and can make it go out. just take that red wire that powers the pump and run it to a relay. then ground the relay, run a power wire from the battery to the relay, then the a wire from the relay to the pump. not hard and will save you trouble down the road and it will be like 10 dollars to do so its not much money.
|
Thank you for the info and help. Is it possible to run it to a spare fuse somewhere and achieve the same thing? Ill look into the relay as well.
__________________
2004 D.S.G. Mach 1 Mustang I.U.P.(01/22/2004)-04 Cobra Longblock- Posi Ported M122 GT500 Blower - BF 2.93 Upper - 4lb Lower -MGW STS-Bassani cattless X pipe- Borla Stinger Catback-Steeda Bump Steer kit-MM CCs- MM Coilovers 350lb spring- LFP Heat-exchanger- 1inch Shaker Spacer-03 Cobra IRS with FTBR's Full Bushings kit-BF Diff Brace-3:55 gears -T56 Tranzilla- cut 04 coupe rear springs-Viper Remote Start/Alarm system-Ipod Auxilary-SLP LL-Tune coming soon
|