View Single Post
Old 12-08-2008, 05:49 PM   #5
TorchedMach1
TorchedMach1
 
TorchedMach1's Avatar
 
Join Date: Mar 2006
Location: Phoenix, AZ
Posts: 798
Re: Custom Mach 1 Grill Emblem

Quote:
Looks like I'll be the 2nd person besides you with this .......I'll post some pics on the car as soon as it gets here.

Thanks again, Eddie
So far we will be the only two with anything like it. Let me know when it gets there, and what ya think.

Quote:
Originally Posted by swoop1156 View Post
I like it and I don't like it at the same time. Hmm. I never usually have that problem. But, thanks for showing me what the 99-01 Cobra bumper looks like with the '03 Cobra chin. I was wondering about that.
I was the same way at the beginning along with a few buddies. But it grows on ya quick and we all love it. So buy one! :LAUGH:

Quote:
How well did that chin fit, have to do much to it to make it fit.
I have the mach 1 chin on my 99/01 bumper and it doesnt fit that great
jon
Yeah I've recently took off the that chin. It didn't fit that great either. Somebody should make a cool chin for the 99-01 Cobra Front bumper.
__________________
Arizona's Fastest Mach 1
11.14 @ 120 w/ 1.48 60'
3300 lbs With Driver

GO-FAST MODS
O/R H-Pipe
Magnaflow Catback
K&N FIPK GEN II
Roy's Composite Spacer
T-56 6 Speed
Liberty 26 Spline Input Shaft
Steeda Tri-Ax
Spec Stage 3+ Clutch
Aluminum Flywheel
Aluminum Driveshaft
Built 31 Spline Rear w/ 4.30's
Rear upper and Lower Control Arms
NX Wet Kit (100 Shot)
SCT Chip
Custom Tune by Devin @ www.performancesolutionracing.com
TorchedMach1 is offline   Reply With Quote