View Single Post
Old 04-11-2018, 09:53 PM   #4
littlemags
finally paid for
 
littlemags's Avatar
 
Join Date: Nov 2004
Location: Ypsilanti Twp, Mi
Posts: 4,077
Re: ISO hellion turbo kit pan punch

Quote:
Originally Posted by TKat13 View Post
I do not think I could trust that method; I would rather have a bung welded on, that is what I ended up doing when I did my kit. I have seen that method have oil leaks, not big, just minor drips here and there.

but, if you are looking for alternatives without dropping your pan, I know some guys that bought a large brass plumb bob at Home Depot or Lowes and used that instead. It worked for them.

I'd still prefer to drop the pan and weld an AN fitting on it.
agree...dont do the punch method....for all the money you put into a turbo setup and do a punch into the oilpan...screw that...
either pull the pan or buy a new canton or whatever you like and get a bung welded onto it...
__________________
2004 mach 1-turbo build in progress..
Fast xfi 2.0
OLD combo-
826rwhp/720 trq -100 shot NX
9.13@154 on 100 shot
NEW- in progress...
littlemags is offline   Reply With Quote