Re: Brakes not completely releasing
Quote:
Originally Posted by Derk
I went to change my pads and rotors and noticed I had a little bit of brake drag. I ended up having to replace one caliper because I couldn't get the stock one to retract far enough to get the new pad over the new rotor. Well, after getting it on it was tight and was still dragging so I ordered braided SS MM hoses thinking that might cure the issue but it hasn't. What is my next course of action?
|
If this is for the rear, make sure you aren't using gt pads by accident. They're thicker than mach/cobra pads and will drag on the thicker/vented mach/cobra rotors.
__________________
2004 Mach 1 #6956 5spd w/IUP
Eaton swap, longtubes, built 3.73 SRA
452hp/409tq dynojet🏁
|