Re: Official Whipple/KB/Eaton HP/TQ/mods thread:
I bought the KB because I didn't have the time to piece together a used Termee setup that was complete down to the last nut/bolt and washer. If I did I would have gone that route and put a Whipple on it. The KB makes great hp and instant grunt down low, or anytime for that matter. It doesn't however make outstanding peak torque. I've had mine on for 6k @9lbs and make 486/423 unadjusted. My best time is an 11.8 @116. While I would like that extra torque your average pullied Termee or whippled Cobra does, I don't think my stock reciprocating assembly would hold any more.. especially for this long. So, on a stock Mach block I recomend the KB. Hope this helps answer your question.
__________________
04 O/W 5sp with Kenne Bell 2.1 intercooled kit@ 10lbs.
Last edited by 32VALVR; 07-11-2010 at 01:46 PM.
|