|
Re: Custom Intake Carbureted & Nitrous Setup
Quote:
Originally Posted by Phil
Tammy Chambers took these pics for me of the pistons. Not my purse or hand cream, LOL!
This is a one of a kind J.E. custom 12:1 nitrous piston for a factory bore 4.6l mod motor. The top ring lands are .250" thick. The pic of the underside shows how beefy the piston pin bosses are. They have been shipped to Polydyne coatings in Houston, TX.
|
Purdy . I just got my pistons sent out today .
What were the specs on the other rings if you dont mind ?
PM me if you dont want to give up that info. over the net .
__________________
1331 RWHP 1296 RWTQ 28 PSI
5.3 liter 322.4 cu.in. Big Bore Stroker
HP PNP Heads w/5 Angle Valve Job
HP Custom Cams
ATI Racing TH400 Cheetah SCS Air Assisted Shifter
Strange 31 spline axles w/3:55
F1R Procharger w/Cog Set-up
Magnafuel 750 -10AN Feed -8AN Return
200 Direct Wet w/MSD window switch & controller
Big Stuff 3 w/Gen. 3 Pro EFI system
Kooks 1.78 LTS 3" Custom Exhaust
Tuning by DGR Racing
DYNO KING
|