View Single Post
Old 03-01-2016, 08:29 AM   #58
GhostRiderblk
Mammoth mach
 
GhostRiderblk's Avatar
 
Join Date: Aug 2009
Location: Florida
Posts: 715
Re: sutyak's turbo 2004 Mach 1 build thread

Quote:
Originally Posted by sutyak View Post
Steep is relative. They would only be too steep if I run out of RPM before the end of the 1/4 me. For the street this low compression and big turbo needs some help down low, so it should make it much more fun.
Some insight. Don't base everything off rpms with turbos. That is not how you get them to spool faster in fact it's almost oposite with a higher gear ratio. Spool time is based off exhaust volume, heat, timing, and of course the turbo you pick housings and air rations and such. Most the time it's the air ratio on the housing. You can try different housing and measure back pressure to see if there are any negative effects while obtaining quicker spool times. As far as 4.10s for the street good luck hooking. At 650hp and 315 m/ts full suspension it was a challenge. Assfault sucks.
__________________
2.8 Kb Mammoth LC
Manley pistons teflon coated
Manley Rods
Arp hw
nx N20 kit
GhostRiderblk is offline   Reply With Quote