Quote:
Originally Posted by JaybTorchedMach
Hey Fastlane, what are your mods and what pulley are you running? I'm looking to start an Eaton Swap and am shooting for something along the lines of your numbers.
|
Mods are 96 Cobra cams, LTs, O/R H pipe, Accufab T/B, and the basic supporting mods for the Eaton swap. Other than that, I am running a 3.1 upper and stock lower on a ported blower.
I don't care about the dyno numbers either. I just want a safe tune. As far as the IAT1, I didn't ask if the tuner was logging that. I have the IAT wired into the TMAP sensor on the back of the blower. I will have to setup my SCT for some data logging to see what it is showing for IAT temps.
With the 14* of timing, we are maxxing out the 90mm Lightning MAF and we had to install a BAP to keep the Stryker 340lph fuel pump at less than 95 duty cycle.