07-24-2012, 05:32 PM
|
#592
|
Registered User
Join Date: Feb 2005
Location: San Antonio
Posts: 6,414
|
Re: Eaton Swap.....
Quote:
Originally Posted by agentorangeCH
Hi Guys
I have an urgend question. I removed so far the the intake manifold, waterpump, underdrive pulley, and much more. It runs pretty god at the moment.
The next step what I will do, is to grind off the knock sensor ports. But when I remove them, what should I do with the harness there?? This harness is connected with the engine harness behind the manifold intake, then it goes to the 2 knock sensors, go further to the one Injector and then it connected to another big harness, in the near of the AC compressor.
RECONNECT YOUR HARNESS.
But when I use the 03 engine harness, I dont have this plug for the knock sensors. Can I leave the other plug around the ac compressor unpluged?
DONT USE THE COBRA HARNESS
Next question. On the drive side my engine harness goes to all injectors and is connected to the alternator and the fuse box. Is this a separate cable on the 03 cobra?
SEE COMMENT ABOVE
I added 2 pics and marked it
|
See notes above.
|
|
|