Quote:
Originally Posted by TheBahnBurner
Hey guys, I finally pulled the trigger on the following items to replace my tired Mach 460 items. The guys at Crutchfield were very happy to help.
120725512 Metra 72-5512 Speaker Harness 2
109STAGE8 JBL Stage 8602 2
613X8015 Kenwood X801-5 (Refurbished) 1
158XAV651B Sony XAV-W651BT 1
120AFDI5V Metra AFDI-5V 12V-5V Converter 1
120955026 Ford Kit 1
120705701 Metra 70-5701 Wire Harness 1
007CPER417 Crutchfield 4 Channel 17 ft 1
007CK4 Crutchfield Amp Wiring Kit 1
0000190009 Crutchfield MasterSheet™ - FORD MUSTANG
Got all of it for 550 bucks after some discounts. I was wondering if anyone else has used the factory wiring to operate aftermarket components? I plan on removing the factory amps and mounting the Kenwood unit in place while retaining the factory wiring.
|
You will need to use the wiring to the 2.5 inch speakers as the wiring to the 5x7s is for the 'MONO Subwoofer' channel. the 2.5" speakers are driven by the head unit while the 5x7s are driven by the amps. Again, the amps all work in 'mono' and at low frequency. Before I used an amplifier, I installed Infinity 5x7 separates in the doors and rear package tray. They came with a passive crossover, I wired the head unit to power the 2.5" wires, those wires to the passive crossover then new wires from the crossover to the tweeter and 5x7 speakers.
I had an amp for the sub. It sounded pretty good, but, later I added a 4 channel amp for the door and rear tray speakers and ran new speaker wire.