Re: Going to start my port and polish of my intake tonight
Hey, I've been reading this thread over and over for a few months now and I finally got the nerve to tackle it.
For the past 1 1/2 hours I've been disassemblying my intake and finally got the lower intake out. What a pain ERG, bah.
Anyway, I see that people have been epoxying the lower back together. What's everyone's opinion on that? Weld or epoxy? I'll start the grinding tomorrow and the rest of the week.
Last edited by ster!nn; 03-03-2007 at 11:02 PM.
|