View Single Post
Old 10-09-2007, 05:09 PM   #110
jsingletary
Mach Maniac
 
jsingletary's Avatar
 
Join Date: Aug 2003
Location: florida
Posts: 216
Re: Official Procharger HP/TQ/mods thread:

New rebuild
Bottom end: Iron block, CP 9cc dish pistons, manley rods, and stock crank cut 10/10. compression ratio 9.3 to 1.
Head unit: D1SC, 18 PSI, 3.6 pulley
Fuel system: twin super car pumps, dual fpdm, 2 -6 lines into 1 -8 line to cpr fuel rails, and 60# injectors.
Tuner: SCT tuned by George Landis at SRC racing.
Other mods: crower stage 3 blower cams, springs, and retainers. Full catless exhaust.
552 RWHP 484 TQ.
Basicly the new motor made the same power to the tires as the last motor did with 1/2 of a point lower compression.
__________________
Azure Blue 5-spd (IUP)
Wellington Fl.

Mods:
Procharged, SRC shortblock .020 OVER, Crower stage 3 supercharger Cams, Full suspension, Rearend, 3650 trans with 26 spline input shaft & Tripple walbro return fuel system with 80# inj. on E-85

www.srcracing.com

Baseline Dynojet: 275 whp & 309 tq.
Current best: 806 whp & 656 tq. Boosted

Weight W/ driver: 3620

Best 1/4 mile time: 10.988 @130.63
60 ft. time: 1.619
Best MPH 131.41
Best 60 ft. time: 1.565
jsingletary is offline   Reply With Quote