|
Re: Eaton Swap.....
Quote:
Originally Posted by JaybTorchedMach
I was actually looking to sit at 500 not much over, but didn't want to get bashed that my engine is going to blow lol  I've had my eye on your build as well. Seems like anyone that has reached the 500 mark has installed cams. I've also seen a lot of low 400 numbers so I don't want to build and be disappointed when dyno day arrives.
I was planning on doing a 3.1 upper and adding meth to be safe. Of course all the "bolt-ons" are already taken care of minus the TB. Would the pulley be excessive for the stock internals? |
Lol yea I've been told since I'm over the 500 mark it won't last long. But hey, my car has 123k miles and still running hard. Using a 3.1 pulley will get you the power for sure but the tune has to be spot on. Meth kit or killer chiller would be a good option.
__________________
**SOLD**04' Mach 1
-Comp Cams 106100's (deg 106/110)
-Eatonswap with 3.4 Pulley
-Full Exhaust (mac lts & xpipe, sss terminator c/b)
-Built Rear w/ 3.55 gears
[B]-Tuned by Lethal Performance of San Antonio
-510hp/478tq
|