|
Re: kooks and steering shaft once again...
Quote:
Originally Posted by Mach828
pull the steering shaft out from the top like mentioned above. Then slide it through, and guide it in when you put the whole thing in as one.
|
as mentioned in the first post I am trying to put it in from the front, it does not fit because these headers are pieces of ****.
...to top it off I went to plug the O2 sensors into the harness extensions provided by Kooks and they dont ****ing fit. Ive checked 5 different places and I have the correct upstream O2 sensors leaving that kooks sent the wrong harness. Im so beyond over this
__________________
03 dsg mach1 - MPR built 9.5:1 motor, D1, cams, ported intake, full exhaust, magnum t56, built rear, E85 etc...
'12 F150 FX2 Supercrew with Ecoboost daily beater
|