Re: Custom Intake Carbureted & Nitrous Setup
Quote:
Originally Posted by Phil
Some more progress going on. Jeff Chambers modified the MSD pick-up bracket to the MSD 4 flying magnet wheel.. However, as he expected, the belt with factory tensioner will rub on the factory trigger wheel pick-up boss & bottom of tensioner body.
I will be milling the factory pick-up boss off the front cam chain cover & Jeff will be intalling a larger diameter tensioner pulley. This will eliminate all areas that are a rubbing concern with the new belt routing.
|
Purdy !!
If it just bolted on everybody would be doing it .
Beautiful Phil !
__________________
1331 RWHP 1296 RWTQ 28 PSI
5.3 liter 322.4 cu.in. Big Bore Stroker
HP PNP Heads w/5 Angle Valve Job
HP Custom Cams
ATI Racing TH400 Cheetah SCS Air Assisted Shifter
Strange 31 spline axles w/3:55
F1R Procharger w/Cog Set-up
Magnafuel 750 -10AN Feed -8AN Return
200 Direct Wet w/MSD window switch & controller
Big Stuff 3 w/Gen. 3 Pro EFI system
Kooks 1.78 LTS 3" Custom Exhaust
Tuning by DGR Racing
DYNO KING
|