2003-04 Mach 1 Registry Owners Club  

Best Mustang Parts

Go Back   2003-04 Mach 1 Registry Owners Club > Search Forums

Showing results 1 to 20 of 200
Search took 0.30 seconds.
Search: Posts Made By: rich1
Forum: General Registry Discussion 07-27-2019, 02:30 PM
Replies: 15
Views: 448
Posted By rich1
Re: 2020 Corvette. What do you think?

Well the ad said at first the starting price would be $50,000. Car is not even in showroom yet and went to $ 60,000. Several dealers around here are putting a Dealer mark-up of up to $10,000.They...
Forum: Engine & Drivetrain (Including trans & rear axles) 07-27-2019, 02:18 PM
Replies: 7
Views: 286
Posted By rich1
Re: TPS voltage won't go below ~190

This sounds like a bad ground in the wiring . Check engine and PCM wiring harness for proper grounding. Use wiring Diagram for Pinpoint check on PCM outlet plug to see if 1.0 volt is present
Forum: Accessories - Non Performance type add-ons 07-08-2019, 03:43 PM
Replies: 6
Views: 561
Posted By rich1
Re: Car covers

Covercraft is the best for the money you can buy.
Forum: Detailing/Cleaning Tips 05-02-2019, 07:09 PM
Replies: 10
Views: 893
Posted By rich1
Re: Dealing with rock chips

My paint on the bumper was bad too. I took it to a real good paint shop here . They said the paint was not done correct from the factory . They did a perfect match that does not chip or crack for...
Forum: General Registry Discussion 04-22-2019, 04:04 PM
Replies: 16
Views: 463
Posted By rich1
Re: 2020 Hi-Po 4 cyl?

Don't worry Ford is saving the Mustang on Earth Day !
They announced that a new Electric Mustang is in the development stages... LOL. Saving the Earth has a problem that no one wants to discuss....
Forum: Engine & Drivetrain (Including trans & rear axles) 03-15-2019, 11:02 AM
Replies: 15
Views: 563
Posted By rich1
Re: Spark plugs and lack of power

You don't need a Dyno ,get an AFR meter for $ 150 bucks and data log it.
Forum: Engine & Drivetrain (Including trans & rear axles) 03-15-2019, 10:58 AM
Replies: 15
Views: 563
Posted By rich1
Re: Spark plugs and lack of power

If its a Bama tune that is most likely the problem. There has been a lot of talk of the race tune being fueled too aggressive for the street.
I run NGK TR6 plugs ..the fine wire plugs run too hot...
Forum: General Registry Discussion 03-14-2019, 09:02 PM
Replies: 42
Views: 1,201
Posted By rich1
Re: Ford get it together!

The spray bore in the 18/19 block is out of round. Combine this with direct injection and bad ring seal is washing the cylinders down with gasoline. Several 1,500 mile engines have cylinder scoring...
Forum: General Registry Discussion 09-09-2018, 12:12 AM
Replies: 4
Views: 206
Posted By rich1
Re: Making my 2016 5.0 GT Greater

The Steeda rails IRS braces and strut braces are all made of powder coated chrome molly steel and are1/2 the weight of others.
Interior ...carbon dash bezel accent
Exterior ...Drake gas door and...
Forum: General Registry Discussion 09-07-2018, 05:10 PM
Replies: 4
Views: 206
Posted By rich1
Making my 2016 5.0 GT Greater

I have added several things so far...
Ford Performace... hood struts and upper strut brace.
SLP... axle back exhaust
Steeda ...IRS cage braces ,jacking rails, lower sub frame connectors
Forum: Engine & Drivetrain (Including trans & rear axles) 02-07-2018, 08:22 PM
Replies: 8
Views: 1,003
Posted By rich1
Re: K&N RAI really this hard to service?

Ok problem solved then..;). but it really takes about the same time to clean it and reinstall it (5min) or just talk about it.(5min) in the video.:eek:
Forum: General Registry Discussion 02-05-2018, 11:57 PM
Replies: 20
Views: 2,538
Posted By rich1
Re: Got a deal on a 2016 Prem GT

I bought a GT 350 intake kit and going to use the Roush cold air kit with the 105 mm Mass air( Stock is 85mm). The stock 80mm throttle body will be used since the larger 87 mm does not add any hp...
Forum: Fluid Systems (coolant, oil, fuel) 02-05-2018, 05:53 PM
Replies: 112
Views: 54,498
Posted By rich1
Re: Important Information About Mobile 1 Synthetic Motor Oil For Mach 1's

Oil is like BEER everyone has their own brand.:smokin:

I have used Castrol in every thing I have ever owned with zero engine failures. Once I let the dealer change my oil to Motorcraft 5W20 when...
Forum: General Registry Discussion 02-05-2018, 05:26 PM
Replies: 11
Views: 1,030
Posted By rich1
Re: 5.0 vs just the facts please

Well ...all has not been good for the GM boys either.
I can remember when the 1st LS series were coming into the shop with cylinders 7 and 8 with no compression ,cracked rockers or rod knock. We...
Forum: General Registry Discussion 02-03-2018, 07:31 PM
Replies: 11
Views: 1,030
Posted By rich1
5.0 vs just the facts please

I got a s550 with a 5.0 the newest 2015 -17 is even better than the s197 2014 5.0 why ?
The intake has the charge motion plates for better low end power. The heads are a cast version of the Boss...
Forum: Fluid Systems (coolant, oil, fuel) 02-03-2018, 01:15 AM
Replies: 3
Views: 542
Posted By rich1
Re: SVT Focus Pump & Fuel Level

You can bend the float wire and change the level but if the sending unit has a bad spot it will not read right.
Use an ohm meter to check it .Then test the gauge in the dash by grounding it. If it...
Forum: General Registry Discussion 02-02-2018, 01:46 PM
Replies: 16
Views: 922
Posted By rich1
Re: Price for 03 stock Mach1 with under 4k?

Dealer may be ok but still ask to see service records . If the car sat around that long with low miles have all the fluids changed.
Forum: Power Adders 02-02-2018, 12:16 PM
Replies: 10
Views: 1,207
Posted By rich1
Re: Where to buy a complete Procharger D-1SC kit??

Call TRE performance good people & good prices on E- bay too.
Forum: General Registry Discussion 02-02-2018, 12:09 PM
Replies: 16
Views: 922
Posted By rich1
Re: Price for 03 stock Mach1 with under 4k?

Make sure you get a car fax done... a lot of low mile cars are damaged or flooded.
The Bullitt is going to a high priced, wiz bang GT with a GT 350 intake and tune making 475 hp. The GT 350 is now...
Forum: Engine & Drivetrain (Including trans & rear axles) 02-02-2018, 11:59 AM
Replies: 21
Views: 1,860
Posted By rich1
Re: More issues 2.0

Before you change the MAF sensor try cleaning it with a special cleaner for them . This will either confirm or deny your MAF.
The main way water gets into the engine is the shaker to hood seal....
Showing results 1 to 20 of 200

 
Forum Jump

All times are GMT -4. The time now is 09:30 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
(c) 2002-2013 Mach1Registry.com

<