2003-04 Mach 1 Registry Owners Club  

Best Mustang Parts

Go Back   2003-04 Mach 1 Registry Owners Club > Search Forums

Showing results 1 to 20 of 165
Search took 0.01 seconds.
Search: Posts Made By: Captain Obvious
Forum: Technical Q&A. HOW TO's, TSB's & Warranty Items 08-14-2017, 02:52 PM
Replies: 7
Views: 1,088
Posted By Captain Obvious
Re: Need Help with ECU Ground(s)

I'm a clown. What I could peek at was misleading. The CCRM pigtail cannot be reversed, as it appeared to be. This was the best, most well-supported, wrong theory I've ever come up with. It would...
Forum: Technical Q&A. HOW TO's, TSB's & Warranty Items 08-11-2017, 12:34 AM
Replies: 7
Views: 1,088
Posted By Captain Obvious
Re: Need Help with ECU Ground(s)

I do have a build thread on SVTP, but it hasn't been updated for about 8 months. That's how long I've been trying to solve this WOT problem.

I'm 99.9% sure I finally found the issue: my damned...
Forum: Technical Q&A. HOW TO's, TSB's & Warranty Items 08-01-2017, 07:06 PM
Replies: 7
Views: 1,088
Posted By Captain Obvious
Re: Need Help with ECU Ground(s)

Thanks to DSG2003Mach1, here's the information I'm after, straight from the 2003 Ford Mustang shop manual:

http://www.asylent.net/webpage/static/ford-mustang-2003-pcm-ground-1024.png

:thumbsup:
Forum: General Registry Discussion 08-01-2017, 06:53 PM
Replies: 8
Views: 679
Posted By Captain Obvious
Re: Please Help Me Identify ECU Ground(s)

DSG2003Mach1 delivered.

On page 4180 of 4378 in the official 2003 Ford Mustang shop manual, I found the PCM ground information I was after:
...
Forum: General Registry Discussion 07-27-2017, 02:15 PM
Replies: 8
Views: 679
Posted By Captain Obvious
Re: Please Help Me Identify ECU Ground(s)

DSG2003Mach1, thank you in advance!

I'm going to look all the chassis grounds over, follow the wires, and check pigtail connections.
Forum: General Registry Discussion 07-27-2017, 02:13 PM
Replies: 8
Views: 679
Posted By Captain Obvious
Re: Please Help Me Identify ECU Ground(s)

I was only kidding...couldn't help but think of the Chris Rock skit where he tries to buy just one rib and a handful of soda, then whips out $100 bills to pay. :)



Thank you! I plan on...
Forum: General Registry Discussion 07-27-2017, 11:58 AM
Replies: 8
Views: 679
Posted By Captain Obvious
Re: Please Help Me Identify ECU Ground(s)

Wow! I might have to pull a Chris Rock I'm Gonna Git You Sucka-maneuver and see if that dude will sell me just the pages I'm interested in.

On a serious note, I hope this doesn't come down to...
Forum: General Registry Discussion 07-27-2017, 11:13 AM
Replies: 8
Views: 679
Posted By Captain Obvious
Please Help Me Identify ECU Ground(s)

I have some questions regarding ECU ground that I could really use some help with:

1. Where does the power supplied to the coil packs ground at? I'm assuming since the coil packs are powered by...
Forum: Technical Q&A. HOW TO's, TSB's & Warranty Items 07-26-2017, 02:54 PM
Replies: 7
Views: 1,088
Posted By Captain Obvious
Exclamation Need Help with ECU Ground(s)

I've been trying to resolve a spark blowout issue with my rebuilt 2003 Mach1 for longer than I care to admit. Every time I start my car, the dash lights all come on as all of my gauges do a full...
Forum: Power Adders 03-10-2016, 04:36 PM
Replies: 803
Sticky: Eaton Swap.....
Views: 369,421
Posted By Captain Obvious
Re: Eaton Swap.....

Thanks for correcting me, 01yellerCobra. I edited my post so as to save face and prevent misinformation from circulating.

:)
Forum: Power Adders 03-10-2016, 04:34 PM
Replies: 803
Sticky: Eaton Swap.....
Views: 369,421
Posted By Captain Obvious
Re: Eaton Swap.....

I'm deep into the process of Eaton swapping my 2003 Mach1 following a catastrophic engine failure, and I would like to confirm my IAT2 wiring plans. Hopefully the following diagram properly conveys...
Forum: Power Adders 03-10-2016, 04:14 PM
Replies: 803
Sticky: Eaton Swap.....
Views: 369,421
Posted By Captain Obvious
Re: Eaton Swap.....

ASH302, the kit you've linked to is Metco's solution to a lower crankshaft support pulley alternative to the stock component that Ford came up with. It's definitely a nice kit, but it doesn't have...
Forum: Brakes & Suspension 11-27-2012, 10:51 PM
Replies: 8
Views: 2,044
Posted By Captain Obvious
Re: Hydroboost leaking under dash!

I have about 26,000 miles on my 2003 Mach1 and my hydroboost unit recently developed a power steering fluid leak. I was preparing to replace the unit with a new one but luckily discovered that the...
Forum: General Registry Discussion 04-02-2010, 02:20 AM
Replies: 8
Views: 386
Posted By Captain Obvious
Re: Need Help Selecting a Big Brake Kit for 2003 Mach1

Here is a picture of the Wilwood front brake kit I linked to above. This setup would compliment the color scheme of my Mach1 quite well. But obviously the kit is expensive:
...
Forum: General Registry Discussion 04-02-2010, 02:18 AM
Replies: 8
Views: 386
Posted By Captain Obvious
Re: Need Help Selecting a Big Brake Kit for 2003 Mach1

Do either of you two have a picture of this setup handy?
Forum: General Registry Discussion 04-02-2010, 02:16 AM
Replies: 8
Views: 386
Posted By Captain Obvious
Re: Need Help Selecting a Big Brake Kit for 2003 Mach1

Are the fitment problems typically related to wheel diameter or wheel offset?



This is definitely a matter of want. It is fair to say that I regard appearance with the same importance as...
Forum: General Registry Discussion 04-01-2010, 01:59 AM
Replies: 8
Views: 386
Posted By Captain Obvious
Re: Need Help Selecting a Big Brake Kit for 2003 Mach1

The best I can do in finding a complete brake kit is here with Wilwood:
Wilwood Superlite 6R Big Brake Front Brake Kit $2300...
Forum: General Registry Discussion 04-01-2010, 01:13 AM
Replies: 8
Views: 386
Posted By Captain Obvious
Re: Need Help Selecting a Big Brake Kit for 2003 Mach1

To be more specific, my challenge here is finding a front brake kit with a complimentary rear brake kit to go along with it. I am confused as to why this is such a pain. I am able to find front and...
Forum: General Registry Discussion 04-01-2010, 12:28 AM
Replies: 8
Views: 386
Posted By Captain Obvious
Question Need Help Selecting a Big Brake Kit for 2003 Mach1

As typical of one of the forum's worst members, I have once again returned to the community in a moment of need. I am having a tough time deciding what brake components to purchase for my 2003...
Forum: Exhaust System 06-09-2008, 11:41 AM
Replies: 6
Views: 742
Posted By Captain Obvious
Re: Pictures of Kooks Long Tubes Installation (Bandwidth Warning)

I posted this in another thread:



Leaving the k-member in cost us a great deal of time. I'm betting if we did this project again, we could do it in half the time by removing it.

.
Showing results 1 to 20 of 165

 
Forum Jump

All times are GMT -4. The time now is 12:15 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
(c) 2002-2013 Mach1Registry.com

<