Forum: General Registry Discussion
07-14-2018, 04:02 PM
|
Replies: 24
Views: 2,527
Re: Get a compliment? Post it!
I get looks like: "what kind of Mustang is that"?
And now that I took off the hood decal (was evidently improperly installed, as it was bubbling along the edges and came right off without a hair...
|
Forum: General Registry Discussion
05-03-2018, 05:13 PM
|
Replies: 122
Views: 17,169
Re: 2018 Plans for your car.
Anyone know where to get a reasonably priced chin spoiler replacement for '04 Mach? Quick look today I saw $210-$250...seems high for that small piece. Mine has some annoying scrape marks; I sure...
|
Forum: Fluid Systems (coolant, oil, fuel)
05-02-2018, 09:02 AM
|
Replies: 4
Views: 1,851
Re: Fuel pump replacement tips
Great instructions, fastlane.
Definitely get as much gas out of the tank as you can, and have help taking it down and putting it back up.
Clean around the hat before you remove it...little...
|
Forum: Engine & Drivetrain (Including trans & rear axles)
04-30-2018, 09:34 AM
|
Replies: 5
Views: 1,218
|
Forum: General Registry Discussion
04-21-2018, 05:31 PM
|
Replies: 6
Views: 1,282
|
Forum: General Registry Discussion
04-17-2018, 04:52 PM
|
Replies: 10
Views: 1,324
|
Forum: General Registry Discussion
04-14-2018, 04:55 PM
|
Replies: 16
Views: 2,357
|
Forum: General Registry Discussion
04-11-2018, 04:25 PM
|
Replies: 10
Views: 1,399
|
Forum: General Registry Discussion
04-10-2018, 08:53 AM
|
Replies: 12
Views: 1,537
|
Forum: Engine & Drivetrain (Including trans & rear axles)
04-05-2018, 04:12 PM
|
Replies: 15
Views: 2,151
Re: Motor oil
My opinion on oil is 5/20 Mobil 1; have used that brand of full synthetic in different weights/cars for years with great results.
Mine takes 6.5 quarts at oil and filter to bring the level very...
|
Forum: Engine & Drivetrain (Including trans & rear axles)
03-22-2018, 09:12 AM
|
Replies: 8
Views: 1,679
Re: Mercon LV
Motorcraft site has good descriptions of what each type is for.
|
Forum: General Registry Discussion
03-16-2018, 07:49 AM
|
Replies: 7
Views: 1,576
Re: Need to make a choice. Advice please
My two cents: I would take care of the gremlins only, then run the car for a while to decide which way to go; if it keeps giving you grief, time to move on, if not, keep it and make the changes that...
|
Forum: General Registry Discussion
03-08-2018, 07:40 AM
|
Replies: 122
Views: 17,169
Re: 2018 Plans for your car.
Should replace hood decal...starting to show small bubbles along one edge, and have lower outside pad of driver seat recushioned, if that is possible.
|
Forum: Engine & Drivetrain (Including trans & rear axles)
03-05-2018, 09:17 PM
|
Replies: 1
Views: 670
Coil cover gaskets/grommets.
Replaced coil cover gaskets today after reading about water infiltration, but the originals were in fine shape. The bigger issue I think is making sure that the coil wiring lead grommets in the valve...
|
Forum: Fluid Systems (coolant, oil, fuel)
03-05-2018, 09:06 PM
|
Replies: 11
Views: 1,679
Re: Oil Filter Adaptor Gasket - sealant?
Had the same thing happen to me on an '01 Cobra after changing thermostat...scary when that needle just keeps moving! Took me several cycles of filling the tube, running it a little, cool off, etc.
|
Forum: Detailing/Cleaning Tips
03-05-2018, 08:24 PM
|
Replies: 10
Views: 4,671
Re: Spring!
Wow, that is a lot different than what I was thinking; I like the idea of using it while washing and being able to rinse the bar. Gotta try it this spring. Thanks.
|
Forum: Detailing/Cleaning Tips
03-05-2018, 08:58 AM
|
Replies: 10
Views: 4,671
Re: Spring!
Very nice! I have never used clay bar; how do you keep the bar clean?
|
Forum: Engine & Drivetrain (Including trans & rear axles)
02-04-2018, 09:14 AM
|
Replies: 22
Views: 2,195
Re: Project Mach 1
Wow, you have quite a project, but sounds like you are willing to save the car, and that's neat!
|
Forum: 2003-04 Mach 1 - For Sale/Wanted
01-30-2018, 07:41 AM
|
Replies: 11
Views: 1,880
Re: WTB: Stock air intake setup for Mach 1
I hope that someone has the complete setup for you that they are willing to part with; I put mine back to stock and it was kind of a slow process finding the pieces. Got a couple here, and also on...
|
Forum: Engine & Drivetrain (Including trans & rear axles)
01-10-2018, 03:13 PM
|
Replies: 21
Views: 3,214
Re: More issues 2.0
I agree on the grommets; when I changed plugs last winter the left and right holes at the firewall had rust in them...was not too sure what to make of it but then saw discussions on this site about...
|