![]() |
Aftermarket H to factory catback
I searched and gave up........
Anyone hook up an aftermarket H to the factory catback? I know the factory pipes are 2.25" right and the aftermarket midpipes are 2.5", so I was wondering what would be needed to make it work. I have a Mac offroad H coming this week and have Borla ProXS mufflers welded into the factory rear pipes, and just trying to get a head start on the install. I'm not sure what to expect on how the Mac H will connect to the factory rear pipes. |
Re: Aftermarket H to factory catback
it'll bolt right on. no problem.
|
Re: Aftermarket H to factory catback
Really? Great, thanks.
|
Re: Aftermarket H to factory catback
Yep!
|
Re: Aftermarket H to factory catback
I bolted an MRT H-pipe to my stock Cobra cat-back with no problems. It sounded pretty good, a bit louder than stock but with a good tone and no popping on decelleration.
|
Re: Aftermarket H to factory catback
Well decided to start the install tonight, planning on having the Mac piece delivered tomorrow.
-front of car on rhyno ramps: 2 minutes -back of car in the air and on jack stands: 5 minutes -breaking loose factory manifold bolts: 35 minutes LOL! what a PITA those were, but they're off. Now for the O2 plugs, hahahaa! |
Re: Aftermarket H to factory catback
Install is done, no problems at the manifolds, however I have a small leak where the new midpipe meets the factory axle pipes. Can't hear it leak over the noise of the mufflers, but still it's there...... otherwise no problems.
|
All times are GMT -4. The time now is 02:00 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
(c) 2002-2013 Mach1Registry.com