Bilstein B6 rear shocks installation issue
2 Attachment(s)
I need some help. I am trying to install Bilstein B6 rear shocks in my 04 Mach 1. I have the correct part number, Bilstein tech support confirmed. The stem is not long enough or the bushings are two thick. Tech supports only suggestion is to compress the shock by raising the rear end and let the weight of the car compress the lower bushing. I did this but it did not help. Does anyone have any suggestions? How I can compress the bushing for installation? How can I get these installed?
|
Re: Bilstein B6 rear shocks installation issue
I think you may have the bushings in the wrong order. The cone shaped bushing usually goes on the bottom, faces up and goes thru the hole in the chassis. The other bushing goes on the top. Try that.
|
Re: Bilstein B6 rear shocks installation issue
Quote:
|
Re: Bilstein B6 rear shocks installation issue
I had a similar problem when I installed my Tokico D-Specs. This may or may not work for you but I lucked out. Like tech line said, jack up the axle on one side, all the way up. Fully compressing the shock upward. Then I crawled into the rear trunk thru the rear seats. I had the nut for the top of the shock already inside the socket that fit it. Used my body weight on top of the socket and twisted slowly but firmly until it caught some threads but be careful not to cross thread. Once I got enough twists that the nut would hold on by itself, I let the ratchet do the rest of the work. Good luck with it.
Repeat for other side. |
Re: Bilstein B6 rear shocks installation issue
Is there a bump stop under the boot? If so, make sure it's pushed/seated all the way down on the shaft.
|
All times are GMT -4. The time now is 06:47 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
(c) 2002-2013 Mach1Registry.com